Planetary gear reducer fitted Guide

Proper installation, use and maintenance of planetary gear reducer is to ensure that an important part of the normal operation of machinery and equipment, and therefore, when the installation of the planetary gear reducer, be sure to strictly follow the planetary gear reducer fitted guide carefully to install and use .
first step:
Must be confirmed before installing the motor and the planetary gear unit is intact, and carefully check the dimensions of parts and gear motors connected to match.
Step two:
Remove the outer planetary Wuma Reducer screw holes on the dust, and adjust the PCS system clamping ring and its side holes and dust holes are aligned, tighten the inner hexagonal insert, remove the last motor shaft key.
third step:
The planetary gear reducer and motor natural connection, the connection must be consistent when the input shaft concentricity of the planetary gear reducer output shaft of the motor. If the concentricity is inconsistent, it will cause the motor shaft to break or wear worm reducer gearbox.
      In addition, the installation of the planetary gear reducer, and so can not use iron hammer were hitting, prevent axial and radial force is too large, resulting in bearing or gear damage. And be sure to tighten the screws after the installation, and then tightly screw the bolt force. Before installation, the motor input shaft, positioning boss and reducer to connect parts of the anti-rust oil wipe clean with gasoline or zinc sodium and water. Its purpose is to ensure tightness and flexibility of operation connection and prevent unnecessary wear and tear.